ABOUT PROTEUS VSM
Proteus VSM combines a mixed mode circuit simulator based on the industry standard SPICE3F5 with animated component models. The result is a simulation you can interact with while it runs: you operate the switches and the keypads on the schematic as you would on a physical prototype, and the effect appears immediately on the displays, the indicators and the virtual instruments in the design.
Traditionally, circuit simulation has been a non-interactive affair. You draw the circuit, press go, and then study the results in some kind of post processor. That is fine for a circuit which is essentially static in its behaviour, an oscillator which sits there and oscillates nicely at 1MHz for example. It is much less useful for a design such as a burglar alarm, where you want to find out what happens when a would-be burglar keys the wrong PIN into the keypad, because the setting up required becomes quite impractical and you must resort to a physical prototype. Interactive simulation removes that restriction, and allows professional engineers to run interactive simulations of real designs.
Added to this is our unparalleled support for microcontrollers and for literally thousands of embedded peripheral devices. It is possible to simulate a complete microcontroller system, and thus to develop the software for it without access to a physical prototype. In a world where time to market is becoming more and more important this is a real advantage. The processor families supported are covered in the Working with Microprocessors chapter of this manual.
Firmware can be developed in VSM Studio, the integrated development environment supplied with Proteus, which will download, detect and configure the compilers it needs. Alternatively, you can work directly inside a third-party IDE such as STM32Cube or MPLAB and apply the debug file it produces to the schematic part. Both routes drive the same simulation engine. Visual Designer and IoT Builder provide flowchart-based routes onto that same engine.
The animated model architecture is open, so additional animated models may be created by anyone, including end users. Indeed, many types of animated model can be produced without resort to coding. The VSM SDK manual describes how this is done.
On current hardware, simple microcontroller designs simulate at or near real time, and larger designs remain responsive enough for software development.
See Also: